anguo

joined 2 years ago
[–] [email protected] 4 points 5 hours ago

That is the only question I asked it, back when it appeared on my phone.

[–] [email protected] 3 points 2 days ago

Yooodele-hiiiii

[–] [email protected] 2 points 3 days ago

If you know they're already having sex, and you confirmed her parents are OK with her sleeping over, I don't understand why you're asking this question.

[–] [email protected] 3 points 4 days ago (2 children)

I remember abandoning my second Murakami book after another round of jazz, cats and whiskey.

[–] [email protected] 2 points 6 days ago

Glad to hear it!

[–] [email protected] 2 points 1 week ago (2 children)

So I tried holding the one shot button for about 3 seconds this morning, and it keeps going until I stop it.

[–] [email protected] 3 points 1 week ago (1 children)

Have you tried the single shot button instead?

[–] [email protected] 3 points 1 week ago (4 children)

I have the Bambino Plus, and I've done manual shots in the past. It's been a while though. I can test it tomorrow. You might not be holding it long enough, or perhaps even too long?

I've reprogrammed mine to do much longer shots, that could also be an alternative.

[–] [email protected] 7 points 1 week ago

The problem with ones that heat the water is that they need a power outlet close to the toilet. Honestly, you get used to cold water pretty quickly.

[–] [email protected] 6 points 1 week ago (1 children)

You can get a basic brondell toilet seat bidet for around 100$ at Costco. You just attach it to the flush tank water intake. It's a slightly over-pressured tiny jet, so it takes a little getting used to, but it works.

You can also get handheld ones that also attach to the same water source as the toilet (fairly straightforward) that are a bit more comfortable but have a small learning curve (you need to learn to aim, you'll have a few wet accidents at first). I believe Home depot had some last time I checked.

[–] [email protected] 4 points 1 week ago (1 children)

The de facto answer would have been "Firefox" until recently. It is still a good option, but there are signs it has begun enshittifying.

 

This is clearly just AI slop, but I had to share it with someone.

 

The bowden tube between the extruder and hotend somehow got unscrewed, and the extruder just kept unspooling filament around the room, as the printer kept happily going on.

Here's a photo from farther out: 1000010130

 

I upgraded two Prusa MK3s to MK3.9, and ended up with a couple of spare boards, stepper motors and a bunch of other things. So I decided to turn them into a Makelangelo clone!

Since the school I work at had these large standing whiteboards, I designed and printed corner brackets to hold the motors, as well as a base for the electronics.

1000006226

I'm still having trouble with the homing process, but very happy with the results so far!

I'll be posting the firmware and 3d printed files online soon.

 

10000053041000005305

view more: next ›