Steam Hardware
A place to discuss and support all Steam Hardware, including Steam Deck, Steam Machine, Steam Frame, and SteamOS in general.
As Lemmy doesn't have flairs yet, you can use these prefixes to indicate what type of post you have made, eg:
[Flair] My post title
The following is a list of suggested flairs:
[Deck] - Steam Deck related.
[Machine] - Steam Machine related.
[Frame] - Steam Frame related.
[Discussion] - General discussion.
[Help] - A request for help or support.
[News] - News about the deck.
[PSA] - Sharing important information.
[Game] - News / info about a game on the deck.
[Update] - An update to a previous post.
[Meta] - Discussion about this community.
If your post is only relevant to one hardware device (Deck/Machine/Frame/etc) please specify which one as part of the title or by using a device flair.
These are not enforced, but they are encouraged.
Rules:
- Follow the rules of Sopuli
- Posts must be related to Steam Hardware or Steam OS in an obvious way.
- No piracy, there are other communities for that.
- Discussion of emulators are allowed, but no discussion on how to illegally acquire ROMs.
- This is a place of civil discussion, no trolling.
- Have fun.
view the rest of the comments
I tried to open it up, but one of the screws refuses to be removed, I'm looking for the least destructive method to remove it :)
You need to use the right screwdriver. Not one that's close but the right one. This applies to everything. Don't damage your screws! Buy an Ifixit kit and pick up random screwdrivers when you have some extra money.
There's a sort of order from least to most destructive:
Exactly correct driver >
using an elastic band or other thin piece of rubber, between driver and screw, for grip >
different screwdriver that fits differently (e.g. a small flat driver in any cross-headed screw) >
again, with elastic/rubber >
other, unlikely drivers >
other grippy options, like steel wool >
superglue the driver to the screw >
epoxy resin a driver to the screw >
cut a new flat-head into the screw head with a dremel >
use a screw extracting bit >
drill out the screw head >
cut or drill out the plastic surround
I'm sure there's other options I've not remembered. A lot of it depends on which screw is stuck, and how accessible it is.
The screws are also self tapping in case you didn't know, can be destructive putting them back in without being careful lol. Good luck.