Steelmonkey

Hi so my printer was fine until oneday a print finished with some under extrusion, when I check it seems to extruded in little beads (which combine into blobs as seen in the photo) during prints but not when told to extrude through octo print. Brand new filiment so humidity isn't an issue, I've tried leveling the bed (glass with bltouch), using glue stick, cleaning the nozzle, I cleaned the hot end, sniped down the bowing tube and made sure it was flush with the nozzle. I'm at my whits end and am about to start praying to the omnisiere for divine intervention. Any help would be appreciated.

I have a one gallon bottle like a true homie, but the rubber stopper started developing these black spots and no matter how much i scrub it and soke it. Any suggestions how to clean it and anything I can do to prevent it from happening again?

I don't know how but long story short my therapist wants to try a dnd session with me and wants me to dm. Are there any small like one player modules I could run? He wants to play a warlock if that helps.

Title, essential I know there's the usb c power mod, and the capture card mod (hopefully) but is there anything else I should take a look at? Hoping that if I am gonna open up my 2ds I should only have to once.