SpaghettiYeti

joined 2 years ago
[–] [email protected] 3 points 1 month ago (3 children)

Suggestions for local couch coop anyone?

[–] [email protected] 1 points 1 month ago (1 children)

Where do you recommend wholesale purchases from?

[–] [email protected] 2 points 1 month ago

A-a-ron the ripper.

[–] [email protected] 8 points 3 months ago (2 children)

Please, do tell

[–] [email protected] 2 points 4 months ago

Device must be unlocked to install, typically installed by authorities

Its not on the play store

Minimal risk to all

[–] [email protected] 0 points 4 months ago (2 children)

So is there no way to buy your own crypto without this issue? Who is to say he did it to artificially inflate vs he wanted a piece of the pie?

[–] [email protected] 0 points 4 months ago (4 children)

But if you believe in the coin you made, is there a legal issue buying the coin low and selling high? Wouldn't you want your thing to be successful, whatever it is?

I genuinely do not know.

 

This may be the wrong place because it's for Blender art itself.. if so, please remove.

I have an arc. Lets say it's something like the image attached to this post.

How would I bend the tip of one end so the rest of the shape stays uniform and bends evenly / organically? I'm trying to have it keep fairly even proportions and smooth curves.

I've tried a few tutorials on bending, rotating, and they always end up with turns along specific vertices, giving a sharp turn or a stretched effect. "Skew" may be the right term I'm looking for.

 

Hey all,

I've been sitting on a starter kit for a Mega 2560 R3 board and sensors for over a year. I want to get into it, so bad, but I frankly don't have the time to learn to code this with my job the way it is.

Is there a WYSIWYG program anyone favors, especially for someone new to Linux (I'm using a Raspberry Pi 3 Model B running Raspbian and I have a Raspberry Pi 4 Model B too) and Arduino (board model Mega 2560 R3)?

I found these options. Anyone have experience with them?

Visuino

Embrio

 

Hey all,

I've been sitting on a starter kit for a Mega 2560 R3 board and sensors for over a year. I want to get into it, so bad, but I frankly don't have the time to learn to code this with my job the way it is.

Is there a WYSIWYG program anyone favors, especially for someone new to Linux (I'm using a Raspberry Pi 3 Model B running Raspbian and I have a Raspberry Pi 4 Model B too) and Arduino (board model Mega 2560 R3)?

I found these options. Anyone have experience with them?

Visuino

Embrio

view more: next ›