Meshtastic

2360 readers

2 users here now

A community to discuss Meshtastic (https://meshtastic.org/docs/introduction)

Other mesh communities:

MeshCore: !Meshcore@feddit.org Reticulum: !Reticulum@mander.xyz

founded 2 years ago

MODERATORS

Sal@mander.xyz

SenseCap Solar P1 Pro (lemmy.ca)

submitted 2 weeks ago by bowreality@lemmy.ca to c/meshtastic@mander.xyz

12 comments fedilink hide all child comments

Hm, I have an issue my the Solar node. It heats up too much in the sun. The panel getting hot might be one thing but the inside of the box where the batteries are? That worries me.

I installed a BME280 so it sits inside the box and the temperature reading is actually quite helpful here. I pulled the plug when it got to 55C within hours.

Has anybody experienced that? Isn’t that a problem for the batteries? I don’t need this exploding!!

top 12 comments

sorted by: hot top controversial new old

[–] FapFlop@lemmy.world 4 points 2 weeks ago (1 children)

55C isn’t hot for electronics. I would be worried at 90C.

[–] bowreality@lemmy.ca 1 points 2 weeks ago

Good to know but it was just a couple of hours in the sun.

[–] fratermus@piefed.social 2 points 2 weeks ago (2 children)

My solar node sits under a projection where it gets sun in the morning but shade afterward.

[–] bowreality@lemmy.ca 1 points 2 weeks ago

Ah good idea. I had it full on south so maybe I try east of the house. See if it gets enough to charge and then shade. Thanks

[–] spitfire@lemmy.world 1 points 2 weeks ago (1 children)

Will that be enough during winter?

[–] fratermus@piefed.social 1 points 2 weeks ago (1 children)

It was this past winter, but I'm at a pretty low latitude (~31.8°). The SenseCap Solar P1 has a huge 5w panel. I run a Meshcore repeater, also NRF52-based, under the same eaves with only a 1w panel. It stayed up all winter, too.

[–] spitfire@lemmy.world 2 points 2 weeks ago (1 children)

Yeah, that’s much closer to the equator than I am. While this would work for me in the summer it may not in the winter - when temperatures drop well below 0 degrees Celsius (making charging less effective) , and the sun does not shine for that long (shortening the charging time significantly).

[–] fratermus@piefed.social 1 points 1 week ago (1 children)

when temperatures drop well below 0 degrees Celsius (making charging less effective

Paradoxically, solar panels perform better in the cold , at least on MPPT controllers. It won't make a practical difference in your scenario but it's interesting. At least to geeks like me.

[–] spitfire@lemmy.world 1 points 1 week ago (1 children)

But I believe you shouldn’t charge batteries in very cold conditions (below -10C?)

[–] fratermus@piefed.social 2 points 1 week ago

Yeah, both Li-NMC and LiFePO4 can be damaged by charging when cell temps are below freezing. There is some anecdotal evidence that the very low C (current) rates we see with small panels could make it a non-issue. One of my nodes was up over last winter and froze a few times. I haven't observed any capacity reduction although TBF I didn't do any actual capacity tests.

In my campervan where I have a 380Ah LFP bank I use warming pads to keep the cells at human-comfortable temps.

[–] deafboy@lemmy.world 2 points 2 weeks ago (1 children)

Mine shows 44°C using the integrated sensor (27.7°C ambient) at the moment running Meshcore. It's on the roof, so exposed to direct sun all day.

[–] bowreality@lemmy.ca 1 points 2 weeks ago

Hm. I was wondering if mine had a defect. Not sure how to find out if it does though.