Meshtastic

2360 readers

3 users here now

A community to discuss Meshtastic (https://meshtastic.org/docs/introduction)

Other mesh communities:

MeshCore: !Meshcore@feddit.org Reticulum: !Reticulum@mander.xyz

founded 2 years ago

MODERATORS

Sal@mander.xyz

SenseCap Solar P1 Pro (lemmy.ca)

submitted 2 weeks ago by bowreality@lemmy.ca to c/meshtastic@mander.xyz

12 comments fedilink hide all child comments

Hm, I have an issue my the Solar node. It heats up too much in the sun. The panel getting hot might be one thing but the inside of the box where the batteries are? That worries me.

I installed a BME280 so it sits inside the box and the temperature reading is actually quite helpful here. I pulled the plug when it got to 55C within hours.

Has anybody experienced that? Isn’t that a problem for the batteries? I don’t need this exploding!!

you are viewing a single comment's thread
view the rest of the comments

[–] fratermus@piefed.social 1 points 1 week ago (1 children)

when temperatures drop well below 0 degrees Celsius (making charging less effective

Paradoxically, solar panels perform better in the cold , at least on MPPT controllers. It won't make a practical difference in your scenario but it's interesting. At least to geeks like me.

[–] spitfire@lemmy.world 1 points 1 week ago (1 children)

But I believe you shouldn’t charge batteries in very cold conditions (below -10C?)

[–] fratermus@piefed.social 2 points 1 week ago

Yeah, both Li-NMC and LiFePO4 can be damaged by charging when cell temps are below freezing. There is some anecdotal evidence that the very low C (current) rates we see with small panels could make it a non-issue. One of my nodes was up over last winter and froze a few times. I haven't observed any capacity reduction although TBF I didn't do any actual capacity tests.

In my campervan where I have a 380Ah LFP bank I use warming pads to keep the cells at human-comfortable temps.