There seems to be a bit of PLA in the screw hole of the hotend, probably from a previous clog, and that is preventing me from unscrewing it. Any tips?
this post was submitted on 04 Apr 2025
45 points (95.9% liked)
3DPrinting
17397 readers
28 users here now
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or [email protected]
There are CAD communities available at: [email protected] or [email protected]
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Your printer has the hidden ability of being able to melt plastic 😉
Thanks, I was just worried that it could damage the hotend if I were to unscrew it while hot.
As long as your thermistor or heater block doesn't fall out you should be fine. But if you want to be safe, just set it to 200 and then turn it off before you unscrew it so that it won't thermal runaway if it comes apart while working on it.
Thanks very much.