mortrek

I'm pretty new to this. I was considering replacing it with something else because it leaks slightly from the valve if it gets moved around at all, but I don't know what this connection is to start with. It goes to a dishwasher.

I have a friend who lives in a Section 8 housing apartment and the dryer vent (that normally sticks out enough to connect a dryer to) is broken off flush with the wall by previous tenants. I believe it's also glued/foam filled into place, so it can't be easily pulled further out or anything. They'd probably get in trouble if they modified anything excessively anyway. No pictures, sorry.

They have a stacked washer/dryer that works, but cannot use them due to no venting. There is no way that the landlord will fix it, as they refused to fix many bigger, more dangerous things until the state forced them to. They are just stuck with the apartment that they have. Also, they currently have a negative income, so I'd have to fix it out of my pocket. Currently they just walk to a laundry place and pay a bunch of money (that they don't have) to wash their things.

Is there some sort of trick that's still safe, like a metal insert that you can put into the vent to extend it? Some way to make it usable without modifying the building?

This is Washington State, USA, so it'd need to pretty much follow laws/code if at all possible.

Thank you.

Let me know if YT is not acceptable and I'll take it down...

I can't really disable ads anymore thanks to YT, so apologies. Use adblockers if they let you, I guess.

I have a Rexing Dashcam that I've used for a couple years, and lately it's been behaving badly. It works perfectly fine while on, but when it's time for it to shut down, it often will shut off early, then reboot over and over until its internal battery is totally dead.

Everyone on the net says it's a bad card. Nope. It does mess up the card's partition by quitting in an uncontrolled fashion and by rebooting over and over, but I took the thing apart and the real problem was that the little internal battery is swollen and almost dead.

All the battery does is provide the camera with up to 30 seconds to save the currently captured video and perform a controlled shutdown, and as such, it's quite small. The battery in my V1LG was a 602040 3.7V 450mAh lipo. It was pretty badly swollen (they are supposed to be relatively flat). I've ordered a cheap replacement for $7, which is a lot cheaper than a new dashcam.

Anyway, if your dashcam is behaving oddly at power-down, and you've tried different cards with no success, it may be your battery.

I've made a lot of time-lapse videos of plants. Not sure if it fits a "photography" theme.