This is "krill" a 3d printed, handwired 40% keyboard I designed using FreeCAD.
Bottom:
this post was submitted on 09 Feb 2026
50 points (93.1% liked)
Mechanical Keyboards
586 readers
12 users here now
A community for news, discussion, and showing off your mechanical keyboards
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
The plate (where the switches are mounted to) is printed as well. The wiring is done using 1mm copper wire by hand (hence handwired), switches go into 3d printed sockets. There is a nice!nano microcontroller inside mounted in the middle of the bottom.
Here is a picture of the wiring:
Nice