28
What does the bed mesh in Fluidd show? My prints are good, nothing to complain about, but I see the bed mesh doesn't look so good.
(programming.dev)
this post was submitted on 10 Jan 2026
28 points (100.0% liked)
3DPrinting
20892 readers
16 users here now
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or !functionalprint@fedia.io
There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Make sure the edge of your bed isn't resting on something it ought not to be and/or doesn't have any crap stuck to the underside of it. My Qidi has two plastic tabs sticking up at the rear which are supposed to be end stops to assist you in lining up the magnetic plate back onto its base, but if you're not careful you can wind up with the back edge of the base siting on top of them which has the net effect of making the build surface the equivalent of about a 1:64 scale skateboard quarter pipe. This has predictable results if you try to print anything on the back third of it or so.
I have a Concrete slab and a rubber paver underneath. I removed them, cleaned them, put the printer back on, and reran self check. Here's the mesh now. Still a bend, but now everything is on or above the flat plane.
