20
Why does my overhang/bridge look so bad? Isn't this small enough to be done better?
(programming.dev)
this post was submitted on 26 Dec 2025
20 points (100.0% liked)
3DPrinting
20688 readers
61 users here now
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or !functionalprint@fedia.io
There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
I would go back to your CAD model and tweak it for better printability. If it was a model you downloaded and without a source CAD model I would just remodel it myself to be more printable.
It looks to me like that's not a flat area. That's why it's not using parallel lines. If you want good bridging it must be flat.
This is the answer.
Alternatively, use supports.
See if you can change the number of bottom layers or the bottom layer pattern to get a different result.
Honestly, I just keep changing all sorts of bridge related and unrelated settings until it does what I want. Maybe the piece lends itself to being printed on the head or on it's edge (45° tilt) like this: https://www.reddit.com/r/3Dprinting/comments/mhcvut/pro_tip_if_youve_got_a_complex_part_youd_like_to/
Sometimes even layer height can affect bridge behaviour.
But first thing I'd do is to rotate the piece by 90° on the bed and see if the thin bridges that you can see behind the thick curved ones, change their orientation to be short instead of long.
And then try to figure out what makes those thick curved bridges happen.