this post was submitted on 13 Dec 2025
8 points (100.0% liked)

Ask Electronics

3993 readers
1 users here now

For questions about component-level electronic circuits, tools and equipment.

Rules

1: Be nice.

2: Be on-topic (eg: Electronic, not electrical).

3: No commercial stuff, buying, selling or valuations.

4: Be safe.

founded 2 years ago
MODERATORS
DavideAndrea@discuss.tchncs.de
linker3000@discuss.tchncs.de
8
Single ended signal transmission (lemmy.world)
submitted 1 month ago by TelepathicWalrus@lemmy.world to c/askelectronics@discuss.tchncs.de
7 comments fedilink hide all child comments
 

Hi,

I am thinking about the best way to transmit 5 single ended signals from one board to another as well as ground and 2 power rails. I was thinking cat5e cable with a standard rj45 plug but as cat5e is twisted pair I'm concerned about crosstalk.

The cable between the two boards would be a maximum of 50cm. 3 of the signals are addresses for a multiplexer that would change at a maximum speed of 2ms per change. One of the other signals is a 20khz pwm signal. The final signal is a zc detector for mains so max Freq of 100/120hz.

There may be high current switches at ac line frequency (50/60hz) near by.

Would single ended transmission with cat5e cable be okay for this or would I need differential signalling? If I need differential signalling, what sort of cable/connector could I use?

Any help is appreciated

Thanks

you are viewing a single comment's thread
view the rest of the comments
[โ€“] TelepathicWalrus@lemmy.world 1 points 1 month ago (1 children)

Thank you for your response. I was hoping to run the power (3.3v and 24v) through the same cat5e cable. They wouldn't be high current, probably 100ma max. Do you think this would be ok too?

Thanks

[โ€“] dgriffith@aussie.zone 2 points 1 month ago* (last edited 1 month ago)

Would be fine. Maybe a few decoupling/buffering capacitors at the sink end just to help things along, depends if your device has its own supply regulator and etc onboard. A high and low value pair in parallel would be good (eg 100uF electrolytic and 100nF ceramic).