this post was submitted on 13 Nov 2025
15 points (100.0% liked)

3DPrinting

20347 readers
120 users here now

3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.

The r/functionalprint community is now located at: or !functionalprint@fedia.io

There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml

Rules

If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![](URL)

Moderation policy: Light, mostly invisible

founded 2 years ago
MODERATORS
j4k3@lemmy.world
andypiper@lemmy.world
GrayBackgroundMusic@lemmy.zip
15
Crappy filament? (lemmy.world)
submitted 1 week ago by idunnololz@lemmy.world to c/3dprinting@lemmy.world
16 comments fedilink hide all child comments
 

Not sure if anyone has seen this before but I bought two spools of PETG from Elegoo, one in white and one in black. Their regular PETG, not the rapid one.

Yesterday I printed with the white spool and it worked pretty well.

Today I tried to print with the black spool and the filament would not come out of the nozzle. I tried diagnosing the problem and ended up swapping nozzles, taking apart the nextruder and putting it back together. Then I tried printing again and again the filament would not come out. I swapped back to the white filament because at this point I've essentially ruled everything out except the filament and the white filament worked. I then tried the black again and it would not print. I cut off about 10cm of the filament and tried again and same issue. Finally I cut off about another 50cm and now it started to print.

I'm not sure if this has happened to anyone else or if anyone knows what the issue is. It's almost as if the filament refused to melt or had an much higher melting point vs the rest of the spool.

you are viewing a single comment's thread
view the rest of the comments
[–] dual_sport_dork@lemmy.world 3 points 1 week ago (1 children)

If you still have the length of filament you cut off, you can verify your temperature theory pretty easily by loading it up temporarily and trying increasing nozzle temperatures until you get it to extrude. That spool of filament may have been contaminated by having a couple of pellets of the wrong stuff in it. Plain PET (rather than PETG) is most likely, I think, and that stuff won't extrude until you wind your nozzle up to probably about 240° C.

It might have been a diameter issue as well, but I'd doubt it. My printer's drive gears can still grab objects that are quite a bit smaller than the prescribed 1.75mm filament diameter, and if the stuff were so thin or thick it wouldn't feed I think it'd be quite obvious to the naked eye. I imagine this is the case with pretty much any modern printer.

[–] idunnololz@lemmy.world 1 points 1 week ago (1 children)

I was using Prusa's default profile for PETG which heats the nozzle up to 250 C. If you are correct about it being PET, it should still have melted.

[–] dual_sport_dork@lemmy.world 2 points 1 week ago

In that case who knows what it was. This is one of those rare instances where it'd be awesome to have a flame spectrometer.