this post was submitted on 10 Nov 2025
504 points (96.2% liked)
Funny
12351 readers
1388 users here now
General rules:
- Be kind.
- All posts must make an attempt to be funny.
- Obey the general sh.itjust.works instance rules.
- No politics or political figures. There are plenty of other politics communities to choose from.
- Don't post anything grotesque or potentially illegal. Examples include pornography, gore, animal cruelty, inappropriate jokes involving kids, etc.
Exceptions may be made at the discretion of the mods.
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Christ, that’s specific.
Not as specific as it should be. They're all insane with the tools and materials these days.
More like a $600 Damascus steel knife made by another Youtuber that they were given for free, but otherwise this is spot-on.
Things heating up in the woodworker fandom.
It's either Cam's Damascus knife or Chris's Brass Chunky pencil.
That $60 knife is the last one you'll ever need and it's only available at our web shop, Link below.
(Actually just a rebranded Ali Baba drop ship)
Ahem. Dust Extractor
Woodworker here, the reason you use a marking knife rather than a pencil is because it is more precise, in two ways:
A pencil line has width to it. Even a very fine mechanical pencil line. A marking knife has a single bevel, so the cut it leaves looks like |/ The vertical surface is the mark.
If you need to transfer the mark around the board, say for tenoning, you make the first mark, then you turn the board, put the knife in the end of the cut, butt the square against the knife, and then cut. With a pencil you might stair step a bit. Then, when it's time to cut, you can register a chisel against the mark, you can feel when you're in place because it clicks in.
Note I'm talking about chisels here, because you use a marking knife when using hand tool techniques. It doesn't help at all when using power tools like a track saw, so using a marking knife in a power tool workflow is a bit pretentious.
A marking knife does not need to be expensive, you can use an ordinary utility knife to get the job done, and a cheap single-bevel marking knife can be had for a few bucks. I bought mine from eBay for $9.62 American. Or you could buy this weeb shit for $2400.
Yes, a pencil almarknhas width. That's why you choose a side of the line to cut. I've been woodworking for decades, and nobody ever needs more precision than a pencil because wood's movement and change over time is enough to erase that extra precision.
Eh, if I'm doing something like chiseling the shoulders of tenons by hand, I like using a knife to mark that so that I don't stair-step it around the board, plus it makes sure the line that will be visible in the finished product will be straight and not jagged. When marking out for using power tools, I use a pencil, typically a Pilot Sharpwriter. They're cheap as borscht and the spring action they have reduces the amount of lead I break on wood.
Not really. Over half the woodworking channels I watch never count the cost of materials that they already own when they total up the cost.
I'm kind of ok with them not counting the cost of tools, but the materials need to be counted, especially when they are doing something like "how to build a desk for under $50."
Use what you got!... You got a dull kitchen knife? Sure you can make a kitchen cabinet. Here's how you do it...get the dried marine plywood from your walk-in wood dryer. Once you cut all the parts on the bandsaw and planed them on your walk-in planer, then simply feel for splinters. Any splinters can easily be dealt with using your dull kitchen knife. You can also use old used up sandpaper. Once you sprayed it, just put it in your UV curing room with automated venting. It will be ready for the installation crew by tomorrow.