this post was submitted on 13 Nov 2026
1059 points (99.3% liked)

People Twitter

10602 readers
585 users here now

People tweeting stuff. We allow tweets from anyone.

RULES:

  1. Mark NSFW content.
  2. No doxxing people.
  3. Must be a pic of the tweet or similar. No direct links to the tweet.
  4. No international politcs
  5. Be excellent to each other.
  6. Provide an archived link to the tweet (or similar) being shown if it's a major celebrity, figure or any politician
  1. If a tweet (or similar) makes a statement of fact, either mark it as "satire" in the body or provide the original source link backing up the statement (see rule 6)

founded 3 years ago
MODERATORS
 
you are viewing a single comment's thread
view the rest of the comments
[–] 13Tb0@lemmy.dbzer0.com -1 points 1 day ago* (last edited 12 hours ago) (1 children)

I assume that drafting allows them to drive a lower rpm/torque than the front guy, so the car still has some extra for the overtake

[–] Claidheamh@lemmy.dbzer0.com 20 points 1 day ago (1 children)

You assume wrong, rpm correlates directly with road speed, so if you're going a certain speed in a certain gear you'll be at the same rpm, drafting or not.

What drafting allows you to do is use less throttle to maintain the speed (or go faster with the same throttle position).

[–] 13Tb0@lemmy.dbzer0.com 0 points 1 day ago (2 children)

Right, so what is it that makes them be able to accelerate past their opponent? More room for acceleration within the same gear?

[–] LyD@lemmy.ca 4 points 1 day ago (1 children)

Nothing to do with gears. When you're drafting behind an opponent you can accelerate slightly faster than them because you have less wind resistance. You can also reach a higher top speed before the wind resistance is too much for your engine to overcome. Building up enough speed in the draft can let you make an overtake or get alongside before the next corner.

Whether it is actually an effective way to pass depends on the type of car and track. It's an important part of many types of racing but totally ineffective in others.

[–] 13Tb0@lemmy.dbzer0.com 0 points 15 hours ago (2 children)

I know about wind resistance lol. I’m talking about the fact that some extra acceleration can be achieved by lowering the gear. When you overtake someone in your own car yourself (or if you ride a bike it’s more noticeable when you draft behind) you will notice that acceleration is easier if you lower your gear. That’s because you have more torque / angular momentum in a lower gear. Of course that means that you also start your acceleration while still drafting, like you mentioned, but that isn’t the entire effect. Whether that effect is actually strong enough to overtake their opponent is another thing, depending on the car and speed at the time.

[–] LyD@lemmy.ca 1 points 10 hours ago* (last edited 10 hours ago)

Oh, you generally always drive in the lowest gear possible because that's how you go fast. If you are accelerating and downshifting means you will go faster, that just means you made a mistake by not being in the correct gear in the first place.

There are niche situations where someone might want to short shift e.g. fuel saving.

[–] SlurpingPus@lemmy.world 0 points 13 hours ago* (last edited 13 hours ago) (1 children)

some extra acceleration can be achieved by lowering the gear

The only thing that can be achieved by downshifting if you're already at top speed for a particular gear, is making the gearbox shit itself loudly and most likely cease normal operation. Or maybe making the engine stall, which would be the better outcome here.

To downshift safely you need to lower the speed, since the same speed corresponds to higher RPMs at lower gears. The same speed that you're trying to build in the first place. Definitely no one is doing this ridiculous nonsense in racing.

[–] 13Tb0@lemmy.dbzer0.com 0 points 13 hours ago (1 children)

Mate I don’t mean to rain on your parade, but if you want to make overconfident statements like that I suggest you read the web page I linked above to refreshen your knowledge about Newton’s Second Law, torque and angular momentum. There is nothing ridiculous or nonsensical about Newton’s 2nd law and it applies here :)

[–] SlurpingPus@lemmy.world 0 points 12 hours ago* (last edited 12 hours ago) (1 children)

If you want to speak about engines and gears, better get past Newton's laws and learn how engines and gears work. See you when you reach high school, or more likely not, because you'll realize what a crock of bullshit you were writing here.

[–] 13Tb0@lemmy.dbzer0.com 0 points 12 hours ago (1 children)

Wow, doubling down now and acting like a jerk on top of that? No thanks.

This conversation is over, I’m disengaging

[–] SlurpingPus@lemmy.world 0 points 12 hours ago (1 children)

Why disengage? Instead, prove that you're right: borrow a car with a manual gearbox from a relative of yours, redline it in the third gear, downshift to second, and then get back here as to how that went. Just don’t look up what such a maneuver is colloquially called.

[–] 13Tb0@lemmy.dbzer0.com 0 points 11 hours ago* (last edited 11 hours ago) (1 children)

Why? Because you’re starting to act like a jerk and I don’t need any of that?

But fine, I am willing to explain if you’re willing to tone down a bit. To start off: I drove a manual car for a decade until this march. So I kinda know how they work – maybe don’t try to make so many assumptions about who you’re talking to.

And who said anything about redlining? The point is that the drafting car is not redlined. Nor is the one in front, they just can’t accelerate any faster because of wind resistance. Your scenario would only occur when both cars are driving at their maximum achievable speeds. That only happens on very few race tracks like this one.

Maybe you can stop getting stuck in the loop where the only possibility is that you’re right and I’m wrong, but instead explore the possibility that you may learn something.

[–] SlurpingPus@lemmy.world 0 points 11 hours ago* (last edited 11 hours ago) (1 children)

Your scenario would only occur when both cars are driving at their maximum achievable speeds. That only happens on very few race tracks like this one.

No, it would occur when the cars are geared properly for the track that they're driving at. Which is what racing teams do, because they aren't too stupid as to leave speed on the table. And shifting is basically the same between cars on the same track, since they achieve about the same speed at the same points of the track, if the engines are close in performance. It's not like you're gonna be drafting behind someone going for an overtake, while still having gobs of rpms to spare.

[–] 13Tb0@lemmy.dbzer0.com 0 points 10 hours ago (2 children)

They’re not leaving any “speed on the table”, a race track has turns. So like I said, maximum achievable speeds are rarely achieved and only on a few race tracks. Of course the cars are geared for the specific track they’re racing on, but that doesn’t mean they are always at their maximum power.

Drafting is exactly what allows a car to achieve higher speeds with at lower RPM, because it allows the pursuer to short shift and get into a higher gear than the person in front of them. So yes, they would have RPM to spare since they’re in a higher gear and can shift down for more power.

[–] SlurpingPus@lemmy.world 0 points 7 hours ago* (last edited 7 hours ago) (1 children)

Even in NASCAR on superspeedways downshifting to overtake wouldn't make sense. Even when you sit in the slipstream for the whole lap and are constantly looking for an overtake. Even when you lose barely any speed in the banked turns and can ride the whole track in one gear. Even if you set the fourth and fifth gears very close, but leave some overhead on the fifth from the top speed — still, downshifting wouldn't make sense because racing drivers upshift only when they reach the redline on the lower gear in the first place. Otherwise they would be losing speed when accelerating through the gears. The very premise from which you're working, that the lower gear has better acceleration, ensures that the driver wouldn't upshift at that speed anyway. And after they upshift, they reach a higher speed that's beyond the redline on the lower gear.

[–] 13Tb0@lemmy.dbzer0.com 0 points 3 hours ago (1 children)

I’m not talking about superspeedways, that’s exactly the scenario where downshifting wouldn’t make sense because a car will not achieve its top speed in a lower gear. I don’t know much about nascar as a European, but the races I (rarely) watch have much more turns and they don’t reach top speeds except for tracks like Monza with its very long straights. I don’t think they will always even be in their highest gear between two turns.

When I was driving my own manual car it definitely helped to shift down to overtake a car, even at higher speeds. It’s a short but noticeable boost.

I also ride a road (racing) bike and both the drafting and downshift are very noticeable. When you draft you can shift up and cycle at lower cadence with much less effort. Then if you want to overtake you can accelerate much faster in the lower gear than you would at the higher gear. Of course you can also stay in the higher gear and stand up on the pedals, but that is like turning on another engine (engaging different muscles), which is an option a car simply doesn’t have.

So in short, I still don’t see how a racing car engine is so different that these simple laws of physics wouldn’t apply.

[–] SlurpingPus@lemmy.world 0 points 3 hours ago (1 children)

Did you miss the part where, by your own logic, as well as by actual racing practice, the driver wouldn't shift into the higher gear if there's still acceleration left in the lower gear? If you find that you can downshift to go faster, that just means that your upshifting pattern is dumb and wrong.

At this point you're either confused beyond repair in this topic and can't even see it, or are just smoothsharking and pretending to be thick — neither of which make a good case for continuing trying to make you see the light.

[–] 13Tb0@lemmy.dbzer0.com 1 points 1 hour ago

Did you miss the part where, by your own logic

No need to become pedantic again… let’s have a grown up discussion on Lemmy, not a slap fight on Reddit.

the driver wouldn't shift into the higher gear if there's still acceleration left in the lower gear?

Maybe you misread that.

dumb and wrong.

Not if they know anything about Newton’s law.

you're either confused beyond repair

Both doubtful.

I simply disagree with you and you haven’t made a decent case.

Seeing as this is going the wrong way again, I’m once again disengaging and blocking. Goodbye.

[–] SlurpingPus@lemmy.world 0 points 9 hours ago (1 children)

You know you can just get any decent racing simulator game and test your theories? Wherein 'Forza Horizon' and 'NFS' aren't decent sims.

You aren't getting significant advantage from drafting unless you're at a high speed, i.e. at those same long straights for which gearing is tuned. If the car isn't close to redlining the last gear when it reaches the speed where drafting allows for overtaking, that means it lost speed that it could've been gaining during the acceleration by having closer gearing.

Maybe your hypothesis works in bus racing, I'm not familiar with that.

[–] 13Tb0@lemmy.dbzer0.com 0 points 4 hours ago

Why would I need a racing sim? You told me to take a manual car and test it, which I have been doing for the last 10 years…

And mate, I also routinely ride a road (racing) bike. Drafting is extremely noticeable upwards of 25 kph.

Lastly, in in my EV it is noticeable at highway speeds when I lock my adaptive cruise control to the shortest option behind an SUV, which is still quite some distance, but the projected battery capacity on arrival goes up after a few km of drafting.

[–] oxideseven@lemmy.ca 2 points 1 day ago (3 children)

Nothing. That's the whole point of the topic. It's all nonsense.

Stuff like that doesn't happen in real racing. In real racing you usually pass someone by pressuring them to make a mistake or forcing them to make an opening in a corner. Some motor sports have boost mechanics like DRS or electric boost and stuff but those are limited to specific areas with specific rules on their use. It's not the winning strategy usually.

[–] Claidheamh@lemmy.dbzer0.com 2 points 17 hours ago (1 children)

Drafting is a huge part of most motorsports (f1 included) in real life. It just doesn't look like the movies.

[–] SaveTheTuaHawk@lemmy.ca 0 points 9 hours ago (1 children)

It used to be a huge part of F1 but since the cars rely heavily on downforce the following car cannot get too close because of turbulent air, so F1 introduced a gimmick of wing flaps for the following car.

Great example of an enshittified sport.

[–] Claidheamh@lemmy.dbzer0.com 1 points 7 hours ago

No, it very much still is.

[–] 13Tb0@lemmy.dbzer0.com 0 points 14 hours ago

On the contrary, it happens all the time. In car racing, but also in the TdF for example.

DRS is mostly a F1 thing, and doesn’t have that much to do with what’s being discussed here, because it makes a physical change to the car itself. And of course if you get to turn on a second engine that’s something else as well.

[–] Natanael@infosec.pub 1 points 1 day ago

There's also tracks which doesn't let you maintain top speed. But the car in front can still keep blocking unless it's a wide track (so basically some off-road racing I think)